Pacific CLD 480 Radiator Pacific CLD 480 Radiator Pacific CLD 480 Radiator Pacific CLD 480 Radiator Pacific CLD 480 Radiator Pacific CLD 480 Radiator
Pacific CLD 480 Radiator

Pacific CLD 480 Radiator

Out of stock
P/N
CL-W283-CU00BL-A
AUD$259.00
High-performance radiator. Engineered with high-density copper, double-fin layout and quality materials.

Pacific CLD 480 Radiator

The Pacific CLD Series Radiator is a copper radiator built with an highly efficient double-fin design and a brass tank. The radiator is compatible with 120mm high-static pressure fans with 40mm thickness for optimal heat dissipation, the CLD series is manufactured with a “reflow soldering manufacturing process” which provides exceptional cooling performance.

1 inch = 25 Copper and Brass Fins
(1inch = 2.54cm)

 
High-Quality Copper & Double Fin Radiator Design
 
Optimized Heat Dissipation & Dual-Row Copper Tubes with a Brass Tank
Based on our reflow soldering manufacturing process, the Pacific CLD Series is engineered with a thick 40mm radiator along with dual-row 12-set flat tube design and a brass tank. The radiator is optimized for efficiently which allows even heat dissipation from your internal components.
Image Displayed: Pacific CLD 240
Pacific CLD Series Radiator Models
240mm: 285.4 x 119 x 40
360mm: 406 x 119 x 40
480mm: 526.6 x 119 x 40
 
 

Cautions

Thermaltake recommends the following steps to be taken before using the Pacific series radiators and water blocks

  • To ensure a clean loop, flush and rinse your radiators and water blocks with distilled water prior to use.
  • Do not use tap water or distilled water as your coolant, it may harm your loop and reduce performance.
  • It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while protecting the entire liquid loop from corrosion.
  • Before storing your water cooling components, please clean, rinse and dry. This will ensure a longer lifespan for your components.

Thermaltake recommends the following steps to be taken after completing your water loop setup

  • It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while preventing the entire cooling system – copper, brass, nickel, aluminum, and steel – from corrosion.
  • Fill the reservoir with coolant and cycle the power on and off several times while the pump pushing the coolant into the loop.
  • DO NOT let the pump run dry, when there is no liquid entering the pump turn off your power immediately
  • Fill the reservoir to the top as it will prevent air from going into the pump
  • If necessary tilt the system slightly from side to side to bleed the air out of the loop.
  • Place some paper towels under fittings and joining points to test for leaks.
  • Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop.
  • Before starting, flush out your system correctly to prevent any coolant or unwanted particles sticking to your tubes, radiators and other cooling components.
  • Coolant might fade over time.
More Information
P/N CL-W283-CU00BL-A
Dimensions 526.6(L) x 119 (W) x 40(H) mm
Weight 1300 g
Material Copper
FPI (Fin per inch) 25
Flat Tube 12-set
Thickness 40 mm
Parts Stopper *3 (G 1/4 )
Screw Thread G¼” * 5