Thermaltake P1000 Pastel Coolant - Yellow Thermaltake P1000 Pastel Coolant - Yellow Thermaltake P1000 Pastel Coolant - Yellow Thermaltake P1000 Pastel Coolant - Yellow
Thermaltake P1000 Pastel Coolant - Yellow

Thermaltake P1000 Pastel Coolant - Yellow

In stock
P/N
CL-W246-OS00YE-A
AU$45.00

1000ml yellow pastel based non-transparent and high performance coolant for PC water-cooling, offering superb protection for copper, nickel, brass, and aluminum.

 
 
Better Formula, For a Better System

Anti-Corrosive Solution

Corrosion protection for copper, brass, nickel, and aluminum.

Antifreeze

Ensures coolant to run effectively under extreme weathers.

Liquid Surface Tension Optimizer

By adding optimizer to increase the surface tension of the coolant, it minimizes the risk of airlock to accelerate the process of starting the system.
 
 
 

Coolant Viscosity at 20°C(m Pa‧s)

  • P1000 Pastel Coolant> 1.42m Pa‧s
  • Other Coolant> 1.93m Pa‧s

Coolant Viscosity at 40°C(m Pa‧s)

  • P1000 Pastel Coolant> 0.89m Pa‧s
  • Other Coolant> 1.2m Pa‧s
 
 
 

Cautions

Thermaltake recommends the following steps to be taken before using the Pacific series radiators and water blocks

  • To ensure a clean loop, flush and rinse your radiators and water blocks with distilled water prior to use.
  • Do not use tap water or distilled water as your coolant, it may harm your loop and reduce performance.
  • It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while protecting the entire liquid loop from corrosion.
  • Before storing your water cooling components, please clean, rinse and dry. This will ensure a longer lifespan for your components.

Thermaltake recommends the following steps to be taken after completing your water loop setup

  • It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while preventing the entire cooling system – copper, brass, nickel, aluminum, and steel – from corrosion.
  • Fill the reservoir with coolant and cycle the power on and off several times while the pump pushing the coolant into the loop.
  • DO NOT let the pump run dry, when there is no liquid entering the pump turn off your power immediately
  • Fill the reservoir to the top as it will prevent air from going into the pump
  • If necessary tilt the system slightly from side to side to bleed the air out of the loop.
  • Place some paper towels under fittings and joining points to test for leaks.
  • Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop.
  • Before starting, flush out your system correctly to prevent any coolant or unwanted particles sticking to your tubes, radiators and other cooling components.
  • Coolant might fade over time.
More Information
P/N CL-W246-OS00YE-A
Capacity 1000 ml
Color Yellow
Hazardous component 1,2-Propanediol< 6%
CAS 57-55-6
EC 200-338-0